Forum Boss
Administrator
A new .22-250 Cartridge Guide will be released with the updated web site in a few days. I'm looking for all options from the 35-35 grainers all the way up to the 80gr match bullets.
Thanks in advance, guys! ;D
(And yes, we have a 6.5x47 guide in the works too -- hopefully by Xmas.)
Format -- Please provide
Bullet mfg, bullet weight, bullet type (e.g. Berger 55gr flat-base hollow point)
Primer brand and type (e.g. Federal LR)
Brass brand (e.g. Lapua 22-250)
Powder Mfg. and type (e.g. Hodgdon H322)
Powder charge in grains
OAL and seating relative to lands (e.g. jumping .035")
Velocity (if known) with barrel length (e.g. 3300 fps in 26" Shilen)
Comments (e.g. "Very accurate load, 1/2" groups, excellent ground hog load that is NOT temp sensitive)
IMPORTANT: If you are running anything other than a standard .22-250 SAAMI chamber be sure to make note of that. We do NOT want to confuse normal loads with AI loads.
You can reply in this thread. However, if it is a hot load, please do not post here, but send email to mailbox@6mmBR.com
You can just copy the following and paste into your post or email message, and add the data:
Bullet mfg, bullet weight, bullet type:
Primer brand and type:
Brass brand:
Powder Mfg. and type:
Powder charge in grains:
OAL and seating depth:
Velocity and barrel length:
Comments:
Thanks in advance, guys! ;D
(And yes, we have a 6.5x47 guide in the works too -- hopefully by Xmas.)
Format -- Please provide
Bullet mfg, bullet weight, bullet type (e.g. Berger 55gr flat-base hollow point)
Primer brand and type (e.g. Federal LR)
Brass brand (e.g. Lapua 22-250)
Powder Mfg. and type (e.g. Hodgdon H322)
Powder charge in grains
OAL and seating relative to lands (e.g. jumping .035")
Velocity (if known) with barrel length (e.g. 3300 fps in 26" Shilen)
Comments (e.g. "Very accurate load, 1/2" groups, excellent ground hog load that is NOT temp sensitive)
IMPORTANT: If you are running anything other than a standard .22-250 SAAMI chamber be sure to make note of that. We do NOT want to confuse normal loads with AI loads.
You can reply in this thread. However, if it is a hot load, please do not post here, but send email to mailbox@6mmBR.com
You can just copy the following and paste into your post or email message, and add the data:
Bullet mfg, bullet weight, bullet type:
Primer brand and type:
Brass brand:
Powder Mfg. and type:
Powder charge in grains:
OAL and seating depth:
Velocity and barrel length:
Comments: