Defiance Tenacity/KRG bravo Action Screw Torque Specs

[Creed Bratton]

Anyone have any recommendations on torque specs for installing my Defiance Tenacity to my KRG Bravo stock? Any difference between the rear action screw torque spec and the front action screw? Thanks.

 

[rijndael]

I have that combination and use 55 inch pounds for the front and 50 for the rear. I've also run 55/55 without issues.

 

[Ranger188]

You are going to get 10 different answers.
I've seen anywhere between 45 & 65
Most will put a little more in the front screw than the rear.
Try a few combinations and see if it makes a difference in groups.
If not, then don't worry to much about it. Just keep them consistent.

 

[Bolt action]

I have that combination and use 55 inch pounds for the front and 50 for the rear. I've also run 55/55 without issues.

This is correct

 

[Dusty Stevens]

If its bedded it wont make a difference. If its not bedded youll have to experiment

 

[Creed Bratton]

Ok, thanks for the suggestions, all.

 

[boltfluter]

For what it's worth I run 45 front and 30 rear. Been my standard for years and has never let me down. Don't have a clue why! Or can't remember! Lol.

Paul

 

[Superjet]

The instructions state:

65 lb-in front and rear with the upward facing rear screw (backbone to grip) loose. After tightening the action, tighten that rear screw to 45 lb-in.