Bench/press layout question

Discussion in 'Reloading Forum (All Calibers)' started by milanuk, Jan 15, 2020.

  1. Shooter13

    Shooter13 Gold $$ Contributor

    Joined:
    Sep 23, 2016
    Messages:
    820
    Stationary 9.5" I just got the QC mounts for 3 single stage presses.
     
  2. milanuk

    milanuk Gold $$ Contributor

    Joined:
    Nov 23, 2004
    Messages:
    3,073
    Gotcha. My concern was about yarding a 650 (or 750) w/ case feeder, bullet feeder, etc. on and off of a quick change mount. Sounds like it is doable, in theory.

    Probably when I get back from the SWN, I'll get a flush mount base with a riser or two, and some QC plates for my Co-Ax, 550, and RCBS Partner for starters. Might go with the adapter plate for the flush mount for now, simply because this isn't the bench I plan on using long term, and I don't want to cut into the top of it.
     
    Shooter13 likes this.
  3. Shooter13

    Shooter13 Gold $$ Contributor

    Joined:
    Sep 23, 2016
    Messages:
    820
    I did the same on the QC with the adapter plate.
     
  4. richardca99

    richardca99

    Joined:
    Mar 4, 2008
    Messages:
    40
    The Inline Fab QC system with riser is money. I have it and use it. Like others, I keep spare single stage presses on the side mount thing, as there is no need to take up that room with infrequently used hardware.
     
  5. Shooter13

    Shooter13 Gold $$ Contributor

    Joined:
    Sep 23, 2016
    Messages:
    820
    I think you COULD do that but I know I don't WANT to do it ;-)
     

Share This Page