Varget thru a drop tube

[oley55]

polycarbonate tubing used/mentioned by PatMiles above available here: https://www.amazon.com/dp/B079J1W4XK/?tag=accuratescom-20

 

[PatMiles]

polycarbonate tubing used/mentioned by PatMills above available here: https://www.amazon.com/dp/B079J1W4XK/?tag=accuratescom-20

Oley,
Thanks for finding them at Amazon. I looked but could not find them.
Pat

 

[PatMiles]

Nice setup. Is it store bought?

The stand is home brew. Having a Bridgeport in the shop sure is fun.

 

[PatMiles]

Pat, how do you ‘modify’ the tubes on your Lathe?

I turn the top of the tube to fit into the brass fitting on the bottom of Saturn funnel and the bottom is bored so the particular cartridge neck will fit into the tube.

 

[BenPerfected]

Nice setup. Is it store bought?

My drop tune set up similar but is diffintely DIY. I use two eye-type tie wraps to screw the tube tight to the bench.
Ben

 

[PatMiles]

View attachment 1080642

My drop tune set up similar but is diffintely DIY. I use two eye-type tie wraps to screw the tube tight to the bench.
Ben

That's a looong way up and down for each cartridge. My back hurts just looking at it.