• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Teslong bore scope

That second
Here is a photo of the new Remington 700 SS 7mm-08 takeoff barrel I just installed. It will never look this good again.

View attachment 1137973 View attachment 1137974[/QUOTE

one is a good pic
Here is a photo of the new Remington 700 SS 7mm-08 takeoff barrel I just installed. It will never look this good again.

View attachment 1137973 View attachment 1137974
That second one is a good example of an uneven lead reamer cut

This affordable scope may get a lot of people attention
 
Got mine yesterday and it won't work with a S10, S7, Tab A, or a Windows 10 computer. I emailed "Richard" at Teslong and it sounds like they will replace it. Only hiccup so far is they want a pic of the rifle bore - told them no can do.
Richard sent me a replacement for one that refused to work on my Windows 10.I had it from China about 1 week after contacting him and it worked perfectly under the camera button on my laptop. Good visuals. Spent the next 6 days cleaning rifle bores. Never had a clue there was so myuch carbon and copper hiding in my bores!!!!!!
 
  • Like
Reactions: SSL
This little varmint got caught walking across the monitor screen. Got him "pinned" down by an inch long sewing needle. This tool just might be the ticket checking for termites. Maybe this one should have been in "warped sense of humor":D

Snap_036.jpg Snap_040.jpg
 
Last edited:
Here is a photo of my M700 24" CM sporter barrel in .22-250, '95 vintage BDL. This has only 60 shots fired for load development using H380 and IMR 4064. Erosion starts with the very first shot. I forgot to enlarge the screen before taking picture.

Snap_012.jpg
 
Last edited:
.....and the badly pitted neck section and bore Snap_016.jpg Snap_019.jpg of my 1938 8mm Turkish Mauser. No doubt from past corrosive ammo.
 
Only one of my Savages has a factory barrel and in all honesty it doesn’t look any worse than the Remingtons, Howa, or CZs that I checked.
+1...I have found the same thing,w/ some newer Remingtons looking the worse...but they seem to shoot fine.
 
Richard sent me a replacement for one that refused to work on my Windows 10.I had it from China about 1 week after contacting him and it worked perfectly under the camera button on my laptop. Good visuals. Spent the next 6 days cleaning rifle bores. Never had a clue there was so myuch carbon and copper hiding in my bores!!!!!!
My replacement one works perfectly!
 
#5 you are correct. That is the chamfer on the flash hole inside of the 28 Nosler once fired case. Not sure how this is manufactured. My bet would be stamped in one of the final draw steps, not cut.

You win nothing.
 
Dgd6mm is correct on #1. The picture shows the propellant charge inside the case of a Remington Hi Speed 40 gr. solid rimfire round.

You win nothing, either.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,887
Messages
2,205,532
Members
79,189
Latest member
Kydama1337
Back
Top