What powder are you using?I just set up my Supertrickler. I have the unit talking to the scale and that seems fine, but something is amiss in regard to powder dispensing. When I attempt to dispense charges the unit bulk dumps about 1.5 grains of powder, then stops and tries to trickle the rest of the way up to the 28.9 grain target weight I input. Obviously this isn't going to work because it will take forever. Not sure what is going on. I made sure to input the correct powder (N133), and I played around with the min and max settings to no avail. I looked on the website in the FAQ section but there isn't anything there. I am not a Facebook user so hoping someone here has an answer and can push me in the right direction? I've sent Rex this same question and I'm waiting to hear back, but I have no clue when that will happen, and I want to get busy loading with this new system.
Since I'm a new user, maybe I missed something in the setup. I really don't know. I'll dig into the manual again. There is a lot of information there. Maybe the answer is there, but I didn't find it. Thanks guys.
Mine came in but I'm in South Dakota so will be next week before I can mess with it!Well, I just pulled the trigger, mid July delivery (maybe). V4 is great so no rush. EDIT: I do wish the V4 was faster but like others have said with the ST the next load is ready before they finish seating the bullet, I'm having to wait on the V4 to finish taking a dump to load. We shall see.
Mine came in but I'm in South Dakota so will be next week before I can mess with it!
Got home Monday evening, tired out of my mine after 2 days of hard driving, Tuesday was a dr appointment and a migraine, Wednesday (today) follow-up on the MRI and chiropractor, so maybe tonight I can open the box!Mine came in but I'm in South Dakota so will be next week before I can mess with it!
Join the Facebook page. Someone there will be able to help you.Well, finally got to mess with mine today and it is not reading the scale. Anyone else have this problem? I have contacted them but the instructions said it wasn't monitored 24/7 so could be a few days before they respond. Bummer.
Waiting for approval.Join the Facebook page. Someone there will be able to help you.
Follow the set up instructions. All issues I have seen have been related to not reading the instructions. I know most of us throw them away before we get started with a project, but in this case, well worth reading. Will eliminate 99% of issues I have seen reported.Well, finally got to mess with mine today and it is not reading the scale. Anyone else have this problem? I have contacted them but the instructions said it wasn't monitored 24/7 so could be a few days before they respond. Bummer.
I did, every single step. It doesn't recognize the scale.Follow the set up instructions. All issues I have seen have been related to not reading the instructions. I know most of us throw them away before we get started with a project, but in this case, well worth reading. Will eliminate 99% of issues I have seen reported.
Take the scale back to a factory reset and start from the beginning. Usually fixes the issue if you pay attention to all the steps. If you have already done this, my apologies, but I have seen this repeat many times.I did, every single step. It doesn't recognize the scale.