Step One....

[Fuj]

CZ AT-One came in a couple of weeks ago. Timney 10 ounce to 2 lb trigger
came in yesterday. It was factory set for 1 lb, and left it as is since the grand-
son will be getting used to it.....Simple install. The c-clip on the pivot pin was
a bit tedious to put back in. It's about the smallest one I ever played with.
Magnetizing the pocket screw driver made it a bit easier. Now on to step 2.....

I'll note that the stock trigger needed to go for just the fact of the over curved
trigger. The flat style of the Timney is nice.

 

[Fuj]

"Step two"

Remove sling stud and install pic rail mount with extension.
I like my bipods out further....

 

[Fuj]

"Step three"

Had a Meuller 40X Target dot salted away for a kids build and
put it to use for the grandson. I had a set of Burris signature rings
and level lying around and put them to good use. The rifle itself
has a 15 MOA rail and with the rings, I added 15 more.

 

[Fuj]

"Step four and five"

8:00 am at the range and dead calm. Initial bore sighting went
easier then expected. I threw a few random shots at steel plates
and felt the bipod being problematic for a good hold and went
to my regular bench setup. Had to use some rags as filler, but
worked out. Now to just get things going, I had some old Remington
target ammo to use up. I think It was around 2 bucks at the time.
I used a 2 inch circle with an inner 5/8th" outside edge circle. At 50
yards, I put the first four high and left. i adjust to that and put 10 in
the center to dirty the barrel......The row of dots were for single shots.
Note the sine wave configuration of the shots on both top line and
bottom ?? Either way, I need to configure this rifle more for off a bag
and rest, and save the bipod for the Rem 597 and Ruger 10/22. My
infamous phrase has always been....."Never let a bad idea go to waste"
And how about the Old stock Remington target ammo ?? I think this
CZ is going to shoot !!