• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Someone want to use QL to estimate my top end so I don't have to pull bullets?

Looking for a top end charge estimate in my 6mm rem AI. Components are scarce and I don't want to pull bullets.

Details:
6mm rem AI
Federal 210m
ww cases, formed
6mm 105 amax
RE-19

Thank you for the help in advance!
 
And a lawsuit could result should a mishap occur due to faulty information. I will NOT provide QL info due to that - especially for max loads.
 
Well I apologize for the request. All I was inquiry was where to expect my final capacity to be. I had to load conservative and make several trips back and forth to the range. My request may have been mis understood.
 
Varmint Master said:
Well I apologize for the request. All I was inquiry was where to expect my final capacity to be. I had to load conservative and make several trips back and forth to the range. My request may have been mis understood.
A couple options:
First, load at the range. It is easy if you are creative.
Second, load up one each from what you think your starting load will be, increasing .3 to .5 grains per case. Shoot from the lowest up until you start seeing signs of pressure, then STOP. You have found the top safe charge one charge below the load that had pressure. I pull all loads above the max charge and reuse components. Nothing wasted but a little elbow grease.
Scott
 
Ya I believe it was too. Was trying to cut down the trips to the range as my presses are bolted down and haven't gotten a range one set up. I didnt think it was a big deal to get an estimate but I apologize for asking.
 
This isn't QL, but my actual loads. Use with caution in your gun.
M700, 28" Hart 1:9 twist. 6mm AI by Dave Tooley.
WW brass, 210M, RE-19, 105 AMax at COAL of 3.035.
48.0 gr showed no pressure signs. Velocity average of 3318 fps.

The 105s shot better with RE-22 in my rifle, but it was close. I could get 0.5 MOA at 100-300 yards with either powder.

Hope this helps, Tim
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,312
Messages
2,216,173
Members
79,543
Latest member
drzaous
Back
Top