Someone want to use QL to estimate my top end so I don't have to pull bullets?

[Varmint Master]

Looking for a top end charge estimate in my 6mm rem AI. Components are scarce and I don't want to pull bullets.

Details:
6mm rem AI
Federal 210m
ww cases, formed
6mm 105 amax
RE-19

Thank you for the help in advance!

 

[AP2020]

Wow, you want a top end load, sight unseen.

Spend the $150, not gonna be your experiment!

 

[dmickey]

Besides which to ask someone to use QuickLoad or any other program is a violation of the copyright laws!

 

[Nomad47]

And a lawsuit could result should a mishap occur due to faulty information. I will NOT provide QL info due to that - especially for max loads.

 

[Varmint Master]

Well I apologize for the request. All I was inquiry was where to expect my final capacity to be. I had to load conservative and make several trips back and forth to the range. My request may have been mis understood.

 

[effendude]

Well I apologize for the request. All I was inquiry was where to expect my final capacity to be. I had to load conservative and make several trips back and forth to the range. My request may have been mis understood.

A couple options:
First, load at the range. It is easy if you are creative.
Second, load up one each from what you think your starting load will be, increasing .3 to .5 grains per case. Shoot from the lowest up until you start seeing signs of pressure, then STOP. You have found the top safe charge one charge below the load that had pressure. I pull all loads above the max charge and reuse components. Nothing wasted but a little elbow grease.
Scott

 

[Dgd6mm]

Varmint Master, I believe your request was misunderstood.

 

[Varmint Master]

Ya I believe it was too. Was trying to cut down the trips to the range as my presses are bolted down and haven't gotten a range one set up. I didnt think it was a big deal to get an estimate but I apologize for asking.

 

[tiny68]

This isn't QL, but my actual loads. Use with caution in your gun.
M700, 28" Hart 1:9 twist. 6mm AI by Dave Tooley.
WW brass, 210M, RE-19, 105 AMax at COAL of 3.035.
48.0 gr showed no pressure signs. Velocity average of 3318 fps.

The 105s shot better with RE-22 in my rifle, but it was close. I could get 0.5 MOA at 100-300 yards with either powder.

Hope this helps, Tim

 

[Varmint Master]

Tim,
Thanks for the reply. I ran my test sat evening. I am loading 51 grns at 3400 with no pressure signs. Shooting 1/4 moa.