Texas Solo
B.S. High Master
I had to adjust my sizing die to bump the shoulder .002". Bolt closure is much better now. But by doing so, I have a problem with the necks being over sized, as in too tight. I hadn't thought about it until my cases got stuck on the 30cal mandrel on my trimmer. I'm getting .003 - .004 neck tension.
I'm OK with buying a new die, but I don't know how a bushing type die would work. Can I still bump the shoulder with it? If I get a neck sizing only die, wouldn't my FL sizing die still be over sizing the neck? Do I need 2 seperate dies? I understand how to measure & order the bushing size I would need. I just don't know how they work.
Federal GM match 308 brass.
I'm OK with buying a new die, but I don't know how a bushing type die would work. Can I still bump the shoulder with it? If I get a neck sizing only die, wouldn't my FL sizing die still be over sizing the neck? Do I need 2 seperate dies? I understand how to measure & order the bushing size I would need. I just don't know how they work.
Federal GM match 308 brass.