• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Loading for the 33-28 Nosler vs the 340 Wby (with Question)

I had a Stainless New M-70 chambered in 340 Wby with a 26" Benchmark #4 fluted barrel in a B&C stock (like the Extreme Weather M-70 stock). With Barnes 225 TTSX I was getting 2975 fps with RL-17 and 2915 FPS with H4831SC. 100 yds three-shot groups were averaging an inch but would occasionally open up to 1.5". That isn't terrible and didn't really affect the utility of the gun, a 8.5 lb elk rifle for carrying around, but I like 3/4" groups at 100 yds from big game rifles.

So it was just a matter of time after I got my lathe that I would try something different on this action. I got the rifle finished a couple days ago. I went with a 26" Benchmark #4 non-fluted barrel (fluting a #4 only saves 2 ounces), the same action, and same stock. I ran a 33 Nosler reamer in another .150" until it headspaced off a 26 Nosler go gauge. I put a 4.5x14x40 AO vs the 3.5x10x40 and my 33-28 Nosler rifle weighs 8.75 lbs w/scope.

Making the cases wasn't terrible. Start with 28 Nosler cases. Neck up to 30 cal in Whidden 300 WSM die (for my BR rifle). It has a nice tapered expander. Then run through an RCBS 325 WSM die. Then size in the 33-28 Nosler bushing die I drilled out. The only issue was the bottom of the neck was .006" larger than the top due to the neck expansion bringing the shoulder up, so I had to neck turn that bulge off.

My best group today was 84 grains of RL-23, just under 3/4", 3058 fps. That was not a max load, but an unbraked 8.75 lb 338 starts to really pack a wallop at 44 ft lbs of recoil. Yes, I have shot bigger rifles with more recoil, but the 375s and 416s give more of a push while the big 338s give a hard snap which takes more getting used to. Besides, I have been shooting almost exclusively 17 lb BR rifles for the last two years.

I really don't want to use my RL-23 in this rifle, as that is the powder my 300 WSM LR BR rifle loves. I am having a hard time deciding which powder to try next. Reasonable choices are: H4831SC, IMR 4955, H-1000, or RL-26. Then again, it's not like I will be shooting THAT much RL-23 in the 33-28, and with the ability to adjust seating depth (unlike with the 340) I have a lot of room to keep tuning.

Thoughts on powders?
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,252
Messages
2,214,900
Members
79,496
Latest member
Bie
Back
Top