Inside case neck chamfer angle

[paulT]

For FTR Shooting Which angle are you guys using when chamfering you .308 lapua palma inside case necks with 200g hybrids the vld or 45deg angle cutter Thanks.

 

[Jason D Hostetter]

I use a vld chamfer on everything, my thoughts are, the angle is irrelevant as long as it's sufficient enough to keep from damaging the bullet, (scoring or peeling the jacket) when seating a bullet.

 

[Straightshooter1]

For FTR Shooting Which angle are you guys using when chamfering you .308 lapua palma inside case necks with 200g hybrids the vld or 45deg angle cutter Thanks.

I like my Layman hand tool where the chamfer is at 22 degree cutting angle. It makes for nice smooth seating.

 

[SKWERLZ]

The vld cutter.

 

[JayHHI6818]

I bought one of these and it is the smoothest inside chamfer tool I have ever used!

SINCLAIR INTERNATIONAL SINCLAIR CARBIDE VLD CASE MOUTH CHAMFERING TOOL

Check out SINCLAIR INTERNATIONAL SINCLAIR CARBIDE VLD CASE MOUTH CHAMFERING TOOL available Online at Brownells Today and many more Chamfer & Deburring products are available in our Reloading Department.

www.brownells.com

 

[D-4297]

I took the VLD cutter out of the handle and put it in a variable speed battery powered drill . It's a 23 degree cutter and works just fine . The drill saves my wrist , too .

 

[JayHHI6818]

I bought the uniformer only and use idrill press.

 

[jackieschmidt]

What ever this is. I have been using the same one for 50+ years.

 

[coldboreshot]

30°

 

[coldboreshot]

Gotta chamfer smoothly. If ya gorilla it, the bullet suffers

 

[JayHHI6818]

Gotta chamfer smoothly. If ya gorilla it, the bullet suffers

Smoothest one I have ever used