Imp wax on neck and shoulder resizing

[SeabeeKen]

Imperial is a pain to remove completely. I'm looking for an alternative that is easier to remove.

That out of the way, I very lightly lube the body and whatever is left on my fingers is spun on the neck.

Best ive ever used and I've tried a few. Comes off easily. Hi lubricity.
All case lube works it way up into the shoulder area just from cases pushing it higher into the die

ROYAL CASE & DIE LUBE Firearm Case Lubricant

ROYAL CASE & DIE LUBE Firearm Case Lubricant is an answer to easy and clean application of a case lubricants.

sharpshootr.com

 

[Uncle Ed]

if you get to much lube on the tapered case body it is forced upward and dents the shoulder. I just tap my index finger lightly in the lube and apply to the case body and shoulder and neck. I then use a Q-tip to lightly lube the inside of the neck. Bottom line less is more.

 

[Geronimo Jim]

what 1 shot said

 

[Longtrain]

Imperial is a pain to remove completely. I'm looking for an alternative that is easier to remove.

I process my brass in complete batches. Everything is deprimed, then a 1/2 hour clean with Dawn, Lemishine and stainless chips, AMP annealed, resized with Imperial. I used to wipe with paper towels (painful), but a 15 minutes wash with chips, etc. and they’re done. We’re talking 500+ Dasher cases.

Dasher’s usually don’t grow, so a little C&D and they’re ready to load. Haven’t had peening issues with short runs with the chips. May take a couple batches to do the all, I’m retired, I’ve got time.

 

[divingin]

Hot sauce on toast is awesome

Try it on popcorn sometime.

 

[M-61]

Roll the case over my RCBS pad. I guess some gets on the neck. RCBS lube. No problems since I started in 1963.
My guess is I’ll stick ( no pun) with it.

 

[bozo699]

Lube on the shoulder of the brass could result in erratic and uneven shoulder bump.

^^^^^^^^^
100% Spot on!…
Wayne