Darrell Holland Chamfer tool reviews?

[DngBat7]

Looking for a good chamfer tool. I know about the KM. I had one and it is obviously nicely I saw the. Darrell Holland. Seems like a nice design and is one of a few on the market that is carbide. Any thoughts?

BMA-CMCT-H BM Case Mouth Chamfer Tool with Handle

Solid carbide construction for long life. If you ever wear it out we will send you another one for free, just cover the shipping.

www.hollandguns.com

 

[liljoe]

I tried one similar to that it could not stop it from chattering.
Joe

 

[rijndael]

I haven't used it, but you should know that their shipping fees are high and they charge credit card fees. I recently bought their Perfect Primer Seater. Shipping and the credit card fee were over $40. You don't get to know shipping ahead of time. Had I known it was $42 on top of the $170 for the part, I would have not bought it.

 

[dogdude]

Ditch it, get the K&M, it's adjustable .

 

[DngBat7]

Thanks everyone.

 

[rjtfroggy]

Why aren't you at the range getting your March scores done?

 

[WSnyder]

I’d say it probably works fine. Made my own and it works great.

Actually made two.




I'm the odd one out it seems. I've owned a K&M forever and although its nice and works fine I use my carbide tools and haven't touched the K&M in who knows how long.

 

[DngBat7]

Why aren't you at the range getting your March scores done?

Just been busy, Hopefully by months end

 

[RegionRat]

I have used carbide tools exactly like the Holland's and they worked great. I already had them in a set of burrs for an air turbine spindle grind tool, so it didn't cost me anything to try it on case necks.

That said, I'm another fan of the K&M. It pilots straighter and is adjustable. It creates a very accurate VLD chamfer for a hand tool. I have the power drive adapter for them, but have never felt like I needed to use them.

 

[DngBat7]

I have used carbide tools exactly like the Holland's and they worked great. I already had them in a set of burrs for an air turbine spindle grind tool, so it didn't cost me anything to try it on case necks.

That said, I'm another fan of the K&M. It pilots straighter and is adjustable. It creates a very accurate VLD chamfer for a hand tool. I have the power drive adapter for them, but have never felt like I needed to use them.

Per everyone’s advise , purchased the KM

 

[JayHHI6818]

I bought a Sinclair last year. Chuck it up in drill press @ 250 rpm’s. Unbelievably smooth cut

Sinclair VLD Chamfering Tool Cutter Only

Sinclair VLD Chamfering Tool Cutter Only

shootingsurplus.com