Custom FL Dies - What company?

[Dusty Stevens]

Do you turn the necks with a quality neck turner? If not i suspect theres your runout

 

[mike06]

Do you turn the necks with a quality neck turner? If not i suspect theres your runout

K&M neck turner. Peterson Brass getting close to 50 reloads on it so far.

 

[Dusty Stevens]

Can you hear your bushing rattle? Have you flipped it over or tried another one?

 

[mike06]

Can you hear your bushing rattle? Have you flipped it over or tried another one?

Just got the Whidden a few hours ago going to get serious with it in the morning. Tried everything with the other tools. The redding type s fl die put the most run out in after sizing. I have been backing off the bushing nut 1/4 turn.

 

[Dusty Stevens]

Just got the Whidden a few hours ago going to get serious with it in the morning. Tried everything with the other tools. The redding type s fl die put the most run out in after sizing. I have been backing off the bushing nut 1/4 turn.

Just back it off far enough to hear the bushing rattle and thats it. The more you back it off the less youll size the neck. Make sure your shellholder is loose in the ram and its not real tight on your case. Sometimes when case heads expand and get tight in the grooves of the shellholder youll get some runout

 

[mike06]

Just back it off far enough to hear the bushing rattle and thats it. The more you back it off the less youll size the neck. Make sure your shellholder is loose in the ram and its not real tight on your case. Sometimes when case heads expand and get tight in the grooves of the shellholder youll get some runout

Thanks Dusty I do float the shellholder but I will check the case head fit closer never thought about that possibility.