annealing machines

[Liven The Dream]

Original Mikes !

 

[Shooter13]

AMP MK 2, I've tried the others but AMP is the way to go, a lot will argue and it did take a while to let go of that much money but I did and my brass gets annealed each and every time it fires.

 

[Larry Koch]

Amp mk 2? What’s the lifespan? How many can be done manually in 15 minutes?

I was about to pull the trigger and I was reading horror stories about the coil going bad, and unless you purchase the auto brass feeder it goes slow. With my home made electric Annealer I can do 1piece of brass ever 4 seconds doesn’t take long to do 200 pieces after a match.

 

[Diverjeff]

Amp mk 2? What’s the lifespan? How many can be done manually in 15 minutes?

I was about to pull the trigger and I was reading horror stories about the coil going bad, and unless you purchase the auto brass feeder it goes slow. With my home made electric Annealer I can do 1piece of brass ever 4 seconds doesn’t take long to do 200 pieces after a match.

I do my 338LM Lapua brass after every firing on a MK II and takes 3 seconds max per piece.

 

[Slowrunning]

If you're doing a large volume, the annealeez is hard to beat. I ran about 2k pieces of 223 today in a little over 3 hours. 10 mins to set up and get running, then load about 200 pieces and walk away, check every 10-15 mins. Accomplished a bunch of other stuff while it was running.

 

[sammyg]

Mikes reloading bench annealer is a nice setup that doesn't cost a arm and leg