Ammo box's for 6mm BR

[Dusty Stevens]

For pure brass storage (no bullets) i use a slip top 45acp box. Its a 50rd box. Hinged lid wouldnt work, these are very compact and store easily with nicely squared off sides

 

[JayHHI6818]

MTM RM-100

6 BR loaded with Berger 105’s

 

[Mike Casselton]

RM-100
RSS-50

The 50 fits better, but I like 100 round boxes

 

[rayporter]

Huntington Die Specialties :: Ammo Boxes :: Hinged Top 175 Pack Ammo Box | J&J

foam protects each cartridge and the box holds 175 cartridges.

 

[Kittitas George]

I used the MTM box marked specifically for the 17 Hornady Hornet. Ten different loads, five rounds each, different powders and different amounts, all labeled for 'load work up'. The box was to tall, the bullets fell out of their holes and got mixed. All the same length, all the same bullets, no bullet puller collet. I knew I was safely under the max so I shot them at gophers, all were "minute of gopher", but I didn't know which were the tightest shooters. I resized the brass, primed, back in the MTM box. I cut a piece of foam rubber to fit in the top of the box to hold the brass in place. When the time came to start reloading, the brass was corroded on the base around the primer, get out the tumbler and the walnut media. It cleaned up OK. Now card board is in the top of the boxes, everything is loaded ready for warm weather and the range. But, I'm still were I was a year ago, and I still need 17 Hornet brass.

 

[Kracken McGraw]

https://www.midwayusa.com/product/1564131668?pid=165053
This one has been recommended here in the past.

 

[EOD Rob]

I use Franklin 7.62x39 cases for both 6.5 Grendel and 6 ACR. They work really well.

 

[urbanrifleman]

I use the R-100 MTM.

Me too. For 6br (which is too short) I buy 10mm craft wood blocks from Amazon and drop one in each cavity with a little glue. Takes only a few minutes sitting in front of the tv. Let dry a few days or use CA for instant bond.

Sounds silly but it really works.

Then the round sits at the correct height.

 

[SmokinJoe]

Another good box that hasn't been mentioned is Berry's. I have been using Berry's for my smaller cartridges for awhile, also use MTM for small stuff and used them when I shot short range BR for both 6BR and 30BR. If you are loading for long range the 22-250 box might be required. I really like the newer boxes, regardless of brand, that have actual hinged tops.

 

[urbanrifleman]

 

[Dave M.]

I use the rss 50 for 6br. I put foam in the top of the box. I load at the house and seat bullets at the range or match. Knock on wood, I haven't spilt a single kernel of powder. You just have to watch which foam you use. Some types of foam the powder sticks to.

You should seat them longer and then reseat at the range

 

[bobinpa]

I really wish they made the RS-S-50 in a 100 round box.

P.S. I know this is an old thread but it has good info, so why not revive it?

 

[JMayo]

I like handles. R100 i put foam in the bottom of the holes, i cut it with a sharpened 45 case.

MTM Deluxe Flip Top Ammo Box Handle 22-250 Remington to 375 H&H Mag

MTM Deluxe Flip-Top Ammo Boxes are the full of features that is not found on any other box manufactured today. They were specifically designed to store...

www.midwayusa.com