After wet tumble inside neck lube ?

[rmist]

I was thinking about the way bullets would seat after you have wet tumbled your brass. I don't have any knowledge of the way they seat..I have a corn cob tumbler. Do the bullets seem to stick in a squeaky clean piece of brass? Do you use something to lube the inside of the neck? If so what do you use?
Thanks again

 

[memo43]

I have used imperial wax, but a bit slow. now I use an old plastic bullet box full of BB's with dry case lube. simply place the necks and a little goes a long way.

 

[jrm850]

I throw them in the corncob or walnut media with a couple cap fulls of nufinish car wax. I doesn't take too long. I wish I could remember which poster turned me on to it, but they seat much smoother than freshly sonic cleaned.

 

[snert]

And when your super clean brass sticks in your die, do not blame the die!

 

[jimcasey01]

Graphite in a small container with #6 or #8 shot.

 

[Pres100]

I throw them in the corncob or walnut media with a couple cap fulls of nufinish car wax. I doesn't take too long. I wish I could remember which poster turned me on to it, but they seat much smoother than freshly sonic cleaned.

I do the same thing but use HBN. Have also tried the NuFinish as well, but really like the HBN

 

[geraldgee]

I wet tumble. Before I reload any brass I clean every neck with a bronze brush wrapped in 0000 steel wool - slick as snot!

 

[Snuggie]

I also use the graphite. Just dip the neck in the little container full of ceramic balls and go with it. Awesome!!

 

[fredhorace77]

i load em, same as brand new brass, i do nothing in terms of lubing the necks.

 

[clrems77]

Graphite in a small container with #6 or #8 shot.

^^^This works great for me^^^

 

[Erik Cortina]

i load em, same as brand new brass, i do nothing in terms of lubing the necks.

I do the same. Clean the brass and seat bullets, never have had an issue.

 

[jsthntn247]

i load em, same as brand new brass, i do nothing in terms of lubing the necks.

I do the same. Clean the brass and seat bullets, never have had an issue.

What are you cleaning with?

 

[Rockfish Dave]

I also use corn cob media with nu-finish.

I have been told by a friend he was getting greater ES with the stainless steel media cleaned brass. I have been doing the corn cob media as a final finish after stainless media cleaning and have not had any issues. A plus is the media lasts for a long long time.

 

[Erik Cortina]

i load em, same as brand new brass, i do nothing in terms of lubing the necks.

I do the same. Clean the brass and seat bullets, never have had an issue.

What are you cleaning with?

Stainless tumbling media.

 

[ericbc7]

I always us redding dry neck lube (with the tiny ceramic beads) even with moly coated bullets. Not because it's neccesary, just because it's part of my routine.