308 advice needed

[kelbro]

Shouldered barrels are easier than dealing with barrel nuts, for sure.

 

[JLT]

Bat Machine, Defiance, Zermatt, Kelbly, Borden and others hold tolerances that enable very quick and repeatable barrel changes. Your Ruckus action is on that list. I swap barrels all the time, and it doesn't take long at all. Many have made the point that Savage/Remage changes take longer. That's true - they take about twice as long to change vs. a custom action.

 

[ELR LVR]

I've done range switches between short- and long-range 6BR barrels. Not that big a deal with a shouldered barrel. I don't use massive torque when mounting though.

Not sure I'd do switches with nutted barrels though; headspace is too fiddly.

Agreed, not much torque needed at all to screw on a barrel
A good snug Hand tight is even good enough, I've done it, playing around with switching barrels
One guy on you tube, did a 1 Mile shot, cold bore....... first round hit
Hand tightening his barrel before the competition.
(Obviously he tested this before as well)
Most of my barrels when I am satisfied with chambering and fitting
Get torqued snug, thats it. When everything is mated well, matched threads and surfaces flat.......
.......I have never had one come loose.
This is for target rifles, Now a field use - hunting rig I would torque tighter though just for assurance.
------------
I'm certain some people may argue with me here, but you must first test light recoiling rifles with a hand tight barrel.......before arguing this fact.

 

[Liven The Dream]

Well just reading this , I want to build another Rifle ?
Being Hocked on 700 SA clone and Chassis and ?? Caliber. 6.5x.308