20 bra

[mokwahlboog]

What die/bushing combos are everyone using for the 20BRA? .. or even the 20 Dasher for that matter?

 

[LoanHarvey]

Greg @ Primal Rights is using a .245 bushing to get from 6mm to 22 cal, then a .223 bushing to take it on down to 20 Cal.

 

[L.Sherm]

I have double ended forming dies to neck my brass down, my dies are custom because the case is straightened out on mine some. Don't see why you couldn't just use the appropriate bushing on a any 6BRA die to do a 20BRA as long as the chamber matches the die. I do it on other calibers just fine.
20Prac, 6.5x300wsm, 30-28 Nosler etc.

 

[Gabe22BR]

I use
265
246
236
After shot one time a 230 from then on

 

[LoanHarvey]

@Gabe22BR - Do you think the Harrell's Precision 6mm BRA FL Resizing die will serve me well, for both necking down and on going use? I will be using Alpha 6 BRA SP OCD brass. Any suggestions on a seating die for that using the 55gr Bergers?

 

[Gabe22BR]

i use a 2.5 Harrell’s die- just for giggles I sent them 20BRAI brass… I received a 20BRAI die- w/ a 20cal hole..
Seater die-
Newton - or -Wilson blank- run in reamer
20Dasher- easy route
20BR- run in reamer- or adjust stem down far enough the die doesn’t touch shoulder

I had no problems with my Alpha , Lapua, Peterson, brass -

 

[nrspence]

@Gabe22BR - Do you think the Harrell's Precision 6mm BRA FL Resizing die will serve me well, for both necking down and on going use? I will be using Alpha 6 BRA SP OCD brass. Any suggestions on a seating die for that using the 55gr Bergers?

I have a harrells full length sizing die in route! I also bought a wilson 6bra chamber seating die with a 20 cal vld seating stem. I’ll report how that works out.