1.119 if I remember right. LarryCan someone help me? I'm trying to find the diameter of a Savage Small Shank barrel at the bottom of the threads. In other words if I machined the threads off a small shank Savage barrel what would the remaining diameter be?
That the large shank Larry1.119 if I remember right. Larry
1.055 is the small larry1.119 if I remember right. Larry
What caliber do you want.LarryThanks, I'm looking to rebarrel an old Mossberg 800B. I've used old Remingtom barrels, but recently saw a Savage barrel in the caliber I want. If memory serves 1.10 is sufficient.
Don't have . Larry1st - 7mm-08
2nd - 243
3rd - 260rem
I'm going to cut it to 14.5" and pin a break on it. Load light projectiles and use it for varmint hunting.
Bolt face is a problem for that caliber .Do you have something else that would fit my intended purpose? I'm not set on those three. I was also considering a 223 barrel and chambering a 5.56X42. Just looking for something that I can load light bullets in and still run fairly fast from a 16" barrel.
Can someone help me? I'm trying to find the diameter of a Savage Small Shank barrel at the bottom of the threads. In other words if I machined the threads off a small shank Savage barrel what would the remaining diameter be?
Can someone help me? I'm trying to find the diameter of a Savage Small Shank barrel at the bottom of the threads. In other words if I machined the threads off a small shank Savage barrel what would the remaining diameter be?