Wilson die question

[Caleb85]

just getting into useing Wilson dies and I have noticed that the neck sizer in only sizing the neck half way down. I am running a Redding bushing in it. Is there someone here that can tell me what I am doing wrong? Thanks

 

[expiper]

you are not doing anything wrong,,,,the die by design leaves some of the neck un-sized to center it in the chamber,,,,Roger

 

[Caleb85]

you are not doing anything wrong,,,,the die by design leaves some of the neck un-sized to center it in the chamber,,,,Roger

So all is good!?

 

[Preacher]

All is good, you need that ledge so the bushing don't fall through, and the ledge is why it don't size all the way down..

 

[Ledd Slinger]

Love the Wilson seaters, but most folks will recommend you full size your brass to control headspacing. At some point, you will need to use a FL sizer when the brass starts getting tight in the chamber from only being neck sized.