Whidden Gunworks Non Bushing Dies with expander ball kit vs bushing die

[Milo 2.0]

Instead of starting a new similar topic, I am bringing this one back.
I got the Full Length Non-Bushing Click die sizer and seater set as well as the expander button set for 6BR. I was considering sending the non-bushing sizer back to swap out for a bushing sizer. I could then play with a bushing and button to really fine tune neck tension.
I am wondering if this is even worth it or just stick with my original non-bushing die and assorted buttons?

Being that either bushings or the buttons come in .001"increments, I wonder where the overlap .0005" would occur if at all. If your neck tension is that finicky, I'd pick between the 2 (say .002-003") and buy custom ground mandrels to set the desired tension after using reg die with no exp ball.

 

[mike a]

Dont do the bushing and expander. I cant even recommend dragging an expander back in after fl sizing im a fan of the bushing only approach. One or the other.

Dusty, with using the expander only are you turning to fine tune neck tension?

 

[Dusty Stevens]

I turn all my brass that matters. I only use fl bushing dies and when i feel like fine tuning neck tension even more i have a porter precision products mandrel die. I do not use an expander in a fl bushing die