Trim/chamfer/debur on progressive, please

[tdogg]

Not sure why you would say that? The chamfer cutter puts a 45d chamfer on the inside. The deburring cutter takes off the burrs.
The chamfer is not as smooth / pretty as a hand-held tool like the K&M Controlled Depth Tapered Reamer, but it works in the sense that the bullets aren't scuffed up or shaved.
push the shellplate up, lower the Lee tool / screwdriver, engage for a few seconds and carry on.
I would hesitate to do this on a fully-automated progressive, the dwell time / your personal reflexes would be straining.

I should have clarified that I motorized the Lee Quick Trimmer and thus it doesn't have a "Chamfer" cutter per se but has two spring steel pieces that are spring loaded to apply downward pressure and thus will take off the dross on the ID and OD of the case mouth.

Deluxe Cutter Assembly

Replace a dulled cutter on 9037 or 90670

leeprecision.com

Cheers,
Toby