Trigger pins for glue in stock

[Adam 6mm build]

I have a Remington 700 sleeved glued in the stock can I get some information on trigger pins I need a couple any information would be great thanks Adam

 

[carlsbad]

So you want the special trigger pins that can be installed without removing the action from the stock? they cost extra.

I'm pretty sure the trigger is held on with pins right now and they are reusable.

I use 1/8" dowel pins. I believe they are 3/4" long.

--Jerry

 

[Fast14riot]

For us cheap bastids, dremel tool shafts are about exactly the right size and length.

 

[dryhumor]

1/8” hardened round stock, cut to length and a little chamfer.

 

[X Ring Accuracy]

Drill bits work too...super cheap. Use the shanks

 

[gunsandgunsmithing]

I'm just guessing the op is referring to pins that have knurled heads that protrude from the stock, but I haven't seen them in a while and always assumed they were made by the Smith or made of something that worked without much trouble.

 

[carlsbad]

I'm just guessing the op is referring to pins that have knurled heads that protrude from the stock, but I haven't seen them in a while and always assumed they were made by the Smith or made of something that worked without much trouble.

I've never seen that...thus my humor isn't as funny as I thought it was.

 

[gunsandgunsmithing]

I've never seen that...thus my humor isn't as funny as I thought it was.

No worries here. As I said, I haven't seen them in a while. Not much need in being able to remove an action from the stock and a clothes iron and about 10 minutes is all it takes, if need be. So, I've converted pinned to trigger hangers as well as just glued em up without pin holes in the stock, in lieu of a weakend wrist for little benefit. And I've seen several br stocks crack in the pin area. Imo, best to get rid of them altogether.