I’m 26” and 0.090 freebore.What's your barrel length? I've seen 80's pushed to almost 3000 in a 26" gas gun with this powder.
I’m 26” and 0.090 freebore.What's your barrel length? I've seen 80's pushed to almost 3000 in a 26" gas gun with this powder.
Glad that is showing better for you.
Now if the rest of us could get hold of some.....
Has anyone shot it in 6 BRA?quest450 et al,
We won't be publishing any 6 Dasher data I am afraid, because we don't have pressure testing capability as it isn't a SAAMI standardized cartridge.
We do have quickload inputs for the new TS 15.5, and have developed a decent amount of other loads that you can use to develop your load. The powder is slower burning than Reloder(R) 15 and Varget, so I might look at those charges as starting points for TS 15.5 load development.
Good luck, and I look forward to seeing your results.
Shoot well,
Paul
I can't raise any on the web site this morning either, so I'll keep trying or maybe give them a ring.Bruno's just got some in.![]()
I can't raise any on the web site this morning either, so I'll keep trying or maybe give them a ring.
I'm still shooting RE15 in XTC even though Varget and ARComp are as good or better when you factor in temperature sensitivity. But, I'm willing to test and run 15.5 when I start up a new upper and give it a go.
...If I can get my hands on some....
Has anyone shot it in 6 BRA?
Are you in the 31-31.5 range,2900 ?Yes. Got some from Praveen to try in the 6 BRA. My testing showed that it was very close to Varget which is my powder for 6 BRA. Close as in at the identical volume I use in Varget, I got the same velocity with 15.5 that I get with Varget. Accuracy was the same as well. 15.5 will have a place in my reloading room for 6 BRA. I'd like to try it in other cartridges as well when time permits.
2909 velocity. Don't have my load data with me but in that range from a charge standpoint.Are you in the 31-31.5 range,2900 ?
Just curious if you were running the low node with RL16, when comparing it to RL15.5?I tried rl15.5 in the score shoot off , williamsport match 10 lg . very poor conditions . this powder yields more velocity than rl 16 . I ran 2 tenths less powder but gained 2.75 moa @ 1000 . 1 shot doubled the group to 11.5" . density is nearly the same as rl 16 . This was a 6.5 x 47 with 140 hyb.
Sir, can you give us a reason for your recent 30% increase in powder prices across the board on your powders?quest450 et al,
We won't be publishing any 6 Dasher data I am afraid, because we don't have pressure testing capability as it isn't a SAAMI standardized cartridge.
We do have quickload inputs for the new TS 15.5, and have developed a decent amount of other loads that you can use to develop your load. The powder is slower burning than Reloder(R) 15 and Varget, so I might look at those charges as starting points for TS 15.5 load development.
Good luck, and I look forward to seeing your results.
Shoot well,
Paul
because 'the customers were willing to pay it in the last few years, and thanks to the usa fuel prices are up which means transportation costs are up"Sir, can you give us a reason for your recent 30% increase in powder prices across the board on your powders?