• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

SuperTrickler Update 3.0

Yeah I think a lot of folks will like v3.0. Normally I shy away from x.0 releases but I know there's been lots of testing on this version and it's been impressive for a while so the released version should be pretty sweet.
 
  • Like
Reactions: BP1
jxb said:
Yeah I think a lot of folks will like v3.0. Normally I shy away from x.0 releases but I know there's been lots of testing on this version and it's been impressive for a while so the released version should be pretty sweet.
Click to expand...
I’ve tried them all. Always went back to 2.2. But this one is good. I like it.
 
It’s hard for me to move away from 2.20.6. I’ve never tried any other version because this one is working good. I have N133 dropping fast and pulldown 8208 running really fast. The 8208 is less than 5 seconds at an 80% success rate. With that speed I’m cool with two out of ten getting tossed back in the hopper. I use two cups to really move things along.
 
jimmymac said:
It’s hard for me to move away from 2.20.6. I’ve never tried any other version because this one is working good. I have N133 dropping fast and pulldown 8208 running really fast. The 8208 is less than 5 seconds at an 80% success rate. With that speed I’m cool with two out of ten getting tossed back in the hopper. I use two cups to really move things along.
Click to expand...
I was running 2.2 and was fine with it. Your speeds are great. I’m the same way I want to go fast.

This one is worth a try. You could order another SD card download 3.0 and the powder files on it. Plug it in if you don’t like it, just put your old card back in.
 
BartsBullets said:
This one is worth a try. You could order another SD card download 3.0 and the powder files on it. Plug it in if you don’t like it, just put your old card back in.
Click to expand...

I've been super hesitant, but like that idea. I'm assuming all I need is a blank card?

On 2.20.6, I really tweaked the settings to make N133 run like I wanted. With the pulldown 8208, I selected H335 as my powder and it is really great. Like you, I want it to run as fast as I can.
 
jimmymac said:
I've been super hesitant, but like that idea. I'm assuming all I need is a blank card?

On 2.20.6, I really tweaked the settings to make N133 run like I wanted. With the pulldown 8208, I selected H335 as my powder and it is really great. Like you, I want it to run as fast as I can.
Click to expand...
Yes a blank card. Here the info from the manual. I didn’t realize the ST needed to format the Card.

Card Type
The maximum card size that is supported is 32GB. When replacing the card, a high-quality SD card such as a Kingston or SanDisk, is highly recommended. A cheaper card may work reasonably well but may slow your system down considerably. Further to this, a cheaper card may not support the
firmware upgrades, as this is very card quality dependent. The card must be fully SD Association compliant.

Card Format.
It is critical that you use the SuperTrickler formatting function and not use a card formatted by a personal computer. Often personal computers do not format to the SD Association specifications. The card might work in general but may not support the firmware updates.

Please see the System – Peripherals – SD card, for details on how to initiate the card formatting function.
 
Upgrading from 2.2 to 3.0 was easy enough but I'm not seeing previously reported performance solely by upgrading. For Varget I'm seeing 30.0gr pours between 4.9-7.5 seconds, which is great btw, approximately 55% of the time. For the remaining 45% I'm seeing over pours of .06gr+ on average. My sense is you still have to manually set/tune the parameters optimally versus the "AI" configuring values for you.

I recommend upgrading to 3.0 when convenient if for no other reason than to familiarize yourself with the updated screens and keep your tuning skills sharp.
 
prone.life said:
Upgrading from 2.2 to 3.0 was easy enough but I'm not seeing previously reported performance solely by upgrading. For Varget I'm seeing 30.0gr pours between 4.9-7.5 seconds, which is great btw, approximately 55% of the time. For the remaining 45% I'm seeing over pours of .06gr+ on average. My sense is you still have to manually set/tune the parameters optimally versus the "AI" configuring values for you.

I recommend upgrading to 3.0 when convenient if for no other reason than to familiarize yourself with the updated screens and keep your tuning skills sharp.
Click to expand...

With 133 the AI got it going without much tweaking. Down to 6 seconds and at 90 percent success. Varget was another story. It took a good bit of playing with but got it going pretty well 8.3 for 100 throws 95% Success rate.
 

Attachments

  • IMG_7462.jpeg
    IMG_7462.jpeg
    336.8 KB · Views: 10
You must log in or register to reply here.

Similar threads

BartsBullets
Setting up SuperTrickler with H4350
Replies
8
Views
928
jxb
jxb
Interesting findings today concerning my Chargemaster.
Replies
5
Views
829
drop_point
WCRC 2-21-10 Match Results
Replies
1
Views
659
morpheus
morpheus

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
166,241
Messages
2,215,164
Members
79,506
Latest member
Hunt99elk

Share This Page

Back
Top