Setting up SuperTrickler with H4350

[BartsBullets]

@jxb I made you a video on using the AI on the SuperTrickler to setup H4350. This with the new 3.0 update. It’s a little slow but I think worth your time. 8.3 sec 25 throws 100% success.

Bart

 

[jimmymac]

Good stuff Bart. Thanks.

 

[jxb]

@jxb I made you a video on using the AI on the SuperTrickler to setup H4350. This with the new 3.0 update. It’s a little slow but I think worth your time. 8.3 sec 25 throws 100% success.

Bart

Thanks Bart, I'll give it a whirl.

 

[Shooter13]

I like the idea of the velcro for the cup to slide on! Won't scar the plastic. Fixing mine now.

 

[RegionRat]

Beautiful drone shot of the range. Thanks for the demo of V3.
Happy New Year and Best Wishes for your 2024 Season!

 

[jxb]

Thanks Bart, I'll give it a whirl.

Can you please post what the pulse change was, I didn't catch it. Or maybe just post a pic of that pulse screen?

 

[Andy Work]

Nice intro music.

 

[BartsBullets]

Can you please post what the pulse change was, I didn't catch it. Or maybe just post a pic of that pulse screen?

Increased it 10 percent 36

 

[jxb]

Increased it 10 percent 36

Bart,

a follow-up on this and firmware v3.0.2 (minor changes from 3.0.0)

v3.0.0 I didn't have any issues with Varget after using your tuning suggestions for that, but I never could get H4350 to do well (well being 90+%).

In the past I found that doing a full factory reset seemed to help the most, so I made sure I had copied off my presets in advance so I wouldn't lose those, then did a full factory reset. I then copied over v3.0.2, my presets, the Powder.dbl (which is same as v3.0.0 had) and also copied the pf.dat into sys/ (in my case I was using a different card from previous testing so that was missing). I updated firmware and made sure my presets were showing up. As expected each requires redoing vibrator settings after fw update, no biggy.

I filled with Varget, primed the tubes, chose my preset and did the vibrator settings. auto for low, 90% for high. I then started testing and within 10-12 I was done and nearly 100%. I cleaned it out for next test.

Filled with H4350, same process except 80% for high (default is 70). Commenced testing and this took a few more overthrows before it started hitting, like 3-4?. After maybe 13-15 total throws it was at 92% and I called it good. Both powders I quit after learning turned off (no more hat). As anyone that's used the ST, this is good stuff. I can simply load cases when ready.

I didn't need to apply any tuning to either of these, learning mode did it all which was nice for a change.

This actually mirrors what I was seeing when I was doing some testing with pre-release code, that if it's acting poorly or erractic then do a factory reset and start fresh with each new firmware release. Just remember to copy off anything you want like the presets file before you do that full reset! Well unless a person likes entering all that stuff in via the menu over and over and over ;-)

Tip for those that like lots of presets with lots of text, do yourself a favor back up your working copy, then add new ones into the file via a proper editor and simply copy the file to the card. -- JB