Got a v4 with an area 419 powder cup. When throwing varget, I'd get a stray kernel or two on the fx-120i plate every 7-10 throws. The funnel was centered over the cup. So I figured there was too much space between the funnel and the cup and the powder was hitting the edge of the cup and falling out. I 3d printed a funnel that extended farther down to reduce that space. I think it helped, but I still get stray kernals every ~15 throws. It's really annoying to have to check the plate from every angle after every throw for fear of there being a kernal or two on the plate throwing off my zero. Anyone run into this? I can 3d print an even lower funnel, but I wonder if the problem isn't that height, but maybe the kernal are falling too fast bouncing out of the cup or something. If it's bouncing out, maybe I lift the cup up so the powder isn't falling as far/fast to reduce odds of it bouncing out?

New lower funnel

Original funnel before extending down


New lower funnel

Original funnel before extending down
