STOCK MODIFICATION FOR TRIGGER

[Webster]

Installing a Jewell trigger in a REM 700 ADL tupperware stock. Can someone provide a good pix showing where and how much plastic has to be removed from the stock. Looks like the safety lever assembly sticks out farther than the stock Rem trigger.

 

[Preacher]

Can't help with a photo, but hunt up a tube of lipstick and coat the safety arm with it and set in in the stock.
Remove it and then remove anything with a coat of lipstick on it..
Thats what I would do...

 

[Big Mc]

Can't help with a photo, but hunt up a tube of lipstick and coat the safety arm with it and set in in the stock.
Remove it and then remove anything with a coat of lipstick on it..
Thats what I would do...

Preacher, what shade do you wear ?? LOL Tommy Mc

 

[LarryDScott]

On any stock, do not let any part of the JEWELL trigger touch the stock.
It was suggested once about an HS aluminum bedding block stock, that if the trigger shoe leaned right or left that action would benefit from a bedding job.
I have removed a slight amount from the inside of the trigger guard to eliminates a touch point. LDS

 

[pirate ammo]

I have removed a slight amount from the inside of the trigger guard to eliminates a touch point.

Had to do the same yesterday for the bolt release, and just a little for the safety.
This is for a trigger @joshb sent me.

 

[joshb]

Had to do the same yesterday for the bolt release, and just a little for the safety.
This is for a trigger @joshb sent me.

Well..........did ya shoot it yet???

 

[pirate ammo]

Well..........did ya shoot it yet???

Not yet, that thing is touchy.

 

[joshb]

Not yet, that thing is touchy.

Yup! They take some getting used to! I set mine so when you “feel it” it’s gone off.
Use those instructions I sent to back it down some. I don’t want ya to shoot your toe off!