I am resizing 7mm/300wby brass and when I resize it it dents around shoulder. It seems to do it more on fired brass vers new brass. Here are a couple pics of it. Ive cleaned the die and it doesnt matter it still does it. Im using RCBS dies.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
necchi said:Hydrolic dent;
too much lube, just lube the body lightly and brush a little inside the neck for the button.
SBS said:One more thing to check. Most FL sizing dies have a vent hole in the side of the die near the top of the threads. Make sure this hole is open using a small paper clip end or large safety pin.
necchi said:SBS said:One more thing to check. Most FL sizing dies have a vent hole in the side of the die near the top of the threads. Make sure this hole is open using a small paper clip end or large safety pin.
Good tip, sometimes we forget that.
The instructions that come with the dies recommends checking the hole,,,
DennisH said:Which spray were you using?