Replacement Primer Jar for Co-Ax Press

[lotech]

I've used a small Vicks VapoRub jar for more than twenty years.

 

[divingin]

Or get the nearest I’d that slips over the tube (5/16 OD if I recall correctly) and clamp it with a worm drive clamp.

Or a bit of electrical tape on the tube to get the slip fit right...

 

[centershot]

Thanks for all of the suggestions. For now, I will use an old powder bottle. If I can find the correct size tubing, may go that route. One thing I discovered is that if the solid tube going to the bottle is dirty, large primers will not go through. Had to clean it with a rod and parch.

 

[danny]

Here are some. More Google searching should yield more variety.

Plastic Jars in Bulk | Food, Beauty & Wellness

Shop plastic jars for food, cream, and health products.

www.containerandpackaging.com

Danny

 

[Rednexx]

Graf has them ,I just ordered one the other day

 

[esromvre1]

I just used a pill bottle

 

[lotech]

I've used a small Vicks VapoRub jar for more than twenty years.

Now that I think about it, I'm pretty sure the original bottle didn't last more than ten years, if that long, but I don't remember for sure when I bought the Co-Ax. Probably in the 1980s.

 

[sundance]

When I have a lot of brass to deprime I take off the jar and put a 5 gallon bucket under the tube. It never misses.

 

[Scalloper]

Thats been my only complaint about the Forester. Mine was always getting plugged up even from day one. Now I decap with a Frankfort decapper before resizing.