Power Attachments for Neck Turning

[Elkbane]

I've just starter neck turning with K&M cutter and power screwdriver. My K&M caseholder seems to wobble a bit and it doesn't snug up enough on the case to hold when I put the screwdriver under a load.

I read the article on the main page by German Salazar. What shellholder adapter is shown in the article?

Any recommendations on which one to purchase that will give a good grip on teh case?

I'd prefer one I can tighten with a wrench. Cases look good so far....just need to upgrade equipment.
Elkbane

 

[cmillard]

check out sinclair international. they make an adapter for a power screwdriver that can use a lee shell holder. as for myself, i just use good old elbow grease to turn necks.