It gets complicated. I have a mill and a lathe only. Essentially this is what I did, start with a 1" hex shaft 12" long. Center drill one end for live center, drill holes in it to mount receiver. This will give you 1.580" offset. Next I milled a plate for a thickness to get me to 2"offset(radius), placed between the receiver(magazine area) and the hex shaft, use the receiver bolts to fasten receiver to hex shaft and mount in lathe, used 180 RPM and shallow cuts, slow feed, takes time.
P-14 P-17 Wing removal/Remodeling
- Thread starter Sniperhandle
- Start date
Upgrades & Donations
This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.