I have run into an issue and need to turn my fired brass down some more. My issue is that I have full length bushing dies and they do not size down the full length of the neck. I need to size down the full length of neck so I can follow up with the expander mandrel and then neck turn.
What options do I have to get this brass neck turned? Or is it ok to use the fl bushing die, expand and then turn even though the full neck is not sized down?
I did not want to spend $60-$80 on a full length die just to get my necks turned and then not use them again.
Thanks
What options do I have to get this brass neck turned? Or is it ok to use the fl bushing die, expand and then turn even though the full neck is not sized down?
I did not want to spend $60-$80 on a full length die just to get my necks turned and then not use them again.
Thanks