Neck turning drill/power source

[boltman13]

I use a Black&Decker cordless screw driver left plugged in and a Sinclair case holder. The Sinclair case holder comes out of the screw driver and the next case is then put in it. I also do a partial neck trim and then a final one. The B&D has plenty of torque for this and it turns at the right speed. A little wooden cradle also helps keep everything from moving too much. Good luck.

 

[pikespeakgoat]

I've used corded drills, cordless drills and cordless screwdrivers. Last year I found a Milwaukee 12v cordless right angle drill, finally a power tool for turning necks that works well for me. The extended paddle switch allows for a fine control of speed.
http://m.homedepot.com/p/Milwaukee-...Right-Angle-Drill-Tool-Only-2415-20/202196520

 

[Killick]

This is my choice---
http://www.homedepot.com/p/Milwaukee-M4-4-Volt-Lithium-Ion-1-4-in-Cordless-Hex-Screwdriver-Tool-Only-2101-20/203857647?&cm_mmc=Shopping|THD|B|0|B-BASE-D25T+Hand+Tools|&mid=BaQ5rTAT|dc_mtid_8903vry57826_pcrid_73529852758671_pkw__pmt__

 

[basshusker]

I just use my Dewalt 20V cordless drill. Never had one issue with using it.

+2

 

[MGYSGT]

Are any of these screwdriver types going to accept the WFT (worlds finest trimmer). Just how are you attaching the hand held type trimmers.

 

[Killick]

Are any of these screwdriver types going to accept the WFT (worlds finest trimmer). Just how are you attaching the hand held type trimmers.

If the drill has a hand tightening chuck, yes. If it has the hex head snap in, no.

 

[P1ZombieKiller]

I just use my Dewalt 20V cordless drill. Never had one issue with using it.

This what I use and I turn about 7,000 cases a year on it. It is my 2nd one. First one was 18 volt and it lasted about 5 years.

 

[bobcat93]

I went with one of the following, and love it. Do some searching and you can find a refurbished for about $60

I use it with the K&M Neck Turning Tool and Shell Holder for turning my 50 BMG Match Brass

http://www.cpomilwaukee.com/factory...2,default,pd.html?cgid=milwaukee-screwdrivers

View attachment 1003482

I'm with you..I like this little driver for neck turning..Powerful, light, some what quiet, charges quickly. Plus good for little jobs around the house..

 

[wedgy]

This one looks exactly like the Skil driver but it's only $10
https://www.walmart.com/ip/Ultra-Steel-4.8v-Cordless-Screwdriver/32983825