I don't know what honing your Forster (sizing die?) would do.
The .2505" is loaded neck, right?
That says your brass is 0.013"+
Any reason you went with a tight neck? planning on Lapua 0.012 neck thickness?
I think with a 0.253 neck you will be close. It you get stickage, neck turn a little.
Have not received my barrel yet so I don't know exactly were it will come in at but it was ordered as a .253 & my brass comes in at .2505 so do you think I should send my Forster to be honed or leave it be??
Thanks