model 7 difference

[roadkill61]

Can someone explain the differences between a model 700 sa and a model 7

 

[mshelton]

It's shorter for one.

 

[ShootDots]

There are actually 2 model 7's. The "Old" one has only 1 (one) screw pilot hole at the rear of the action (for scope mounts) and the "new" one has 2, like a "normal" short action. I have seen the new ones and they appear (not sure) to be a tad bit longer than the old ones too...

 

[Swampbuck]

The model 7 is shorter than the short action 700. They require there own stock and bottom metal. They are great for youth guns or lightweight mountain rifles. They have a shorter bolt stroke too. Any gunsmith who works on 700s can work on a model 7. Accuracy and whatnot are the same. Downside is model 7 has much less aftermarket parts. And may be limited on COAL and AI type modifications. Model sevens come to standard 308, 22-250 and SAUM sizes.

 

[Rustystud]

Due to the fact that Model 7 actions are shorter than Short action model 700s, longer mag boxes are not possible.
There are several variables between the early model 7s and the current model 7s.
Nat Lambeth

 

[Dans40X]

Model Seven rear receiver scope mount hole configuration-
Serial number #762800 on S/S actions & #773800 on blued actions & above have 2each #6-48 tpi tapped holes to allow 2 piece scope bases.
Serial numbered receivers before above listed numbers have 1 each #6-48 tpi tapped hole for 1 piece Seven or 700 S/A scope bases.

Early Seven trigger guard/floorplates differ from current production Seven trigger guard/floorplates.

Action geometry has not changed other than above mentioned tapped hole(s).

Basic trigger groups/housings are interchangeable between Seven's & 700's/40X's.
The bolt release levers & bolt stops of Seven's differ from 700/40X's.

Bolt stops & springs are coil type(aka 721/722)vintage using a 3rd 1/8" diameter pin,where 700/40X bolt stop spring is of torsion spring design.