Looking for 6br load, VV150 witjh 107mk or 105 scenar

[TheSilverFox]

Looking for a 6br load, with VV150 with 107mk or 105 scenar.
With Cci br4 or cci450 primers.

The store was all out of varget and its back ordered.
All they had was vv150 but i've never tried it.

I've looked on the forum and all i found was;
105gr. Lapua Scenar, Lapua brass, CCI BR 4 primer and 31 grains of Vihtavuori N150

 

[Johnsmith]

I think you would find VV 150 too slow for the cartridge. It is a fair bit slower than Varget. More suited to the .260 Remington and similar sized cases.
John Smith

 

[TheSilverFox]

Well, i do have some RL 15 i can get my hands on.

Is there any good loads with that powder?

 

[jb1000br]

R15 is where it's at

I run 30.8, CCI450, Lapua, 105/6/7

You will find something in the 29.5-31.5gn range...

JB

 

[TheSilverFox]

Well,today located 2 pounds of varget and 2 pound of rl 15 and 1000 cci 450's. This stuff is getting hard to find.

 

[chris308]

I`ve had excellent luck with 150 in the smk 107`s...start at 30.0 and go up from there....had good luck with the berger 95vld`s as well but the fps was better with 140...check out earlier posts regarding favorite 6br loads,that`s were i got my info from,excellent info!) chris 308

 

[paulT]

chris, ive also got great results with the 95g molly Vld bergers in my 1 in 10 twist 243, question, up untill i tried the bergers i was shooting molly Lapua 90g scenars in my 243 and was getting v good results but not as accurate as the bergers, could this be down to the Larger diameter of the bergers thus being tighter in my barrel inturn giving better accuracy, paul.

 

[flatlander]

N150 is the powder of choice for my Dashers - I get a little more velocity out of it compared to Varget, ES & SD numbers are a little better on the avg. than Varget, accuracy is at least as good as with Varget, and the first wet patch down the bore after N150 slides right through, instead of feeling like I'm trying to push it through a piece of rusty sewer pipe like it does after Varget. Typical N150 loads in my Krieger Dashers are around 35grs., if that gives you a clue as to how much more case capacity the Dasher has over a std. BR.

 

[jalonen]

I get excellent results with VV N-140, and a 105 grs.Scenars and 107 grs Sierra.