• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Interchangeable Powders Between 280ai and 30-06

As pretty much all the 4350 powders are incredibly hard to find (I have some Acc. 4350), what are some powders that will produce good velocities in both the 280ai 140-160ish grain bullets and the 30-06 150-165 grain bullets.

I have an action going out for a 280ai build, and my entire family shoots the 06 during deer season, so I'll likely handload for them, especially my dad. He's been rifle hunting out of one of my stands the last few years and taken some nice bucks, one being the biggest of his life. That particular deer was taken on the second day, after I had taken one the first day. It was a long shot for our area, and I got the phone call at 730am from my almost speechless father while I was sitting at camp. So I had the luxury of tracking that deer. I wasn't impressed with the performance of the 165gr Rem Corelokt. It was a great hit with little to no blood. I was actually afraid I was going to have to tell my father he clipped him, but I didn't get the nickname bird dog for no reason lol. With my dad staying at last blood, I found the deer folded up about 100yds from where he was shot. What a great feeling finding that deer for my dad. His biggest buck to date and out of stand I had consistently seen the buck out of numerous times in archery season. I don't want to have that fear of not finding a deer again.
Figure I may as well show the picture behind the story.
 

Attachments

  • imagejpeg_0.jpg
    imagejpeg_0.jpg
    416.9 KB · Views: 80
All this may be put on hold for a while. Damn You Covid-19!! I just checked MidSouth and they're out of everything!! I'll check Natchez and the others usuals, but I'm sure they're in the same boat. Unless I can find something locally, I'll probably just play with Varget and AA4350 since I have each on the shelf.
 
As pretty much all the 4350 powders are incredibly hard to find (I have some Acc. 4350), what are some powders that will produce good velocities in both the 280ai 140-160ish grain bullets and the 30-06 150-165 grain bullets.

I have an action going out for a 280ai build, and my entire family shoots the 06 during deer season, so I'll likely handload for them, especially my dad. He's been rifle hunting out of one of my stands the last few years and taken some nice bucks, one being the biggest of his life. That particular deer was taken on the second day, after I had taken one the first day. It was a long shot for our area, and I got the phone call at 730am from my almost speechless father while I was sitting at camp. So I had the luxury of tracking that deer. I wasn't impressed with the performance of the 165gr Rem Corelokt. It was a great hit with little to no blood. I was actually afraid I was going to have to tell my father he clipped him, but I didn't get the nickname bird dog for no reason lol. With my dad staying at last blood, I found the deer folded up about 100yds from where he was shot. What a great feeling finding that deer for my dad. His biggest buck to date and out of stand I had consistently seen the buck out of numerous times in archery season. I don't want to have that fear of not finding a deer again.
Figure I may as well show the picture behind the story.

Sorry I don't have an answer to your Question Craig, but that is a wonderful story about your dad.

Kevin
 
Craig,
I have predominantly worked with 4831 and 4831sc to develop 150 and 168 Accubond LR elk loads.
So far, using the rev8 Nosler book OAL and load recommendations, I am getting 3110fps (ave) with the 150's (sc) and 3005fps(ave) with the 168's, .5gr below max, out of a Kimber 280AI 24" barrel. No wind, 38degF, @6800ft elevation, 18% humidity.
I took a 800+lb cow elk @425yds last season with the 150grABLR load. She dropped like a stone.
S-
 
Though it might be a tad fast for the 280AI, I was pleasantly surprised by he performance of Reloader 16 in my custom 30/06 yesterday.
With 168 grn Berger Hybrids, it was shooting in the .400 group range at 2980 FPS. No pressure signs. The load was 58.2 grns. The barrel is a 25 inch long Krieger.

I picked up a box of Hornady 65 grn SST’s for a comparison. They were averaging 2970.

Reloader 16 loads exactly like 4350 in this Rifle.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,256
Messages
2,215,074
Members
79,496
Latest member
Bie
Back
Top