Inside of necks scratched, hurting accuracy??

[Ben]

I noticed tonight when prepping some brass, that the inside of the necks were scratched by a screw mark on the pilot on my turner where someone tightened the screw down on the pilot. These scratches aren't real deep,I don't have a way to measure them) and they go down into the case about .100 or so. I am wondering if there is a way to smooth them out . How much effect should this have on accuracy, I know it can't be helping anything. I hope that not finding that burr until now didn't cost me 40 new Lapua brass.

-A new pilot will be ordered from Sinclair before turner is used again.

Thanks for any input.

 

[NeilNE]

The marks will smooth out after shooting. For hunting you should not see any difference in your groups. I would not worry to much about it.