• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Inline Fabrication Case ejector?

fatelvis

Silver $$ Contributor
Does anybody use this add-on device on their single stage press (I have a Redding T-7) to kick the processed case into a bin, speeding production time? How do you like it? Thanks for your input!
 
I use one on my Hornady single stage press, and it works well. I use it to kick out cases after depriving and/or resizing, and it works well for that. You can only put a case in the holder after the ram is raised high enough that the spring arm is no longer covering up the shell holder. That’s not a problem for sizing.

But you have to loosen it up and pivot it out of the way of the ram so you can put a charged case in the shell holder and set a bullet on top before seating.

I like it, and would buy it again. Definitely speeds things up when I can use it, just like his videos show.

Neil
 
Yes! It’s fantastic! I would highly suggest this purchase to anyone. Definitely speeds things up and worth every penny.
 
It ejects a case into a bucket or container? How far does it drop? I would be afraid of dinging my precious Lapua brass I’ve spent hours making perfect. Do you have a picture of it?
Wayne
 
It ejects a case into a bucket or container? How far does it drop? I would be afraid of dinging my precious Lapua brass I’ve spent hours making perfect. Do you have a picture of it?
Wayne
Yeah, it has it’s uses but it’s not for your “special” loadings. I use it for pistol and mass produced plinking ammo.
 
Yeah, it has it’s uses but it’s not for your “special” loadings. I use it for pistol and mass produced plinking ammo.

I have a T7 it might be handy for pistol ammo, If I have a bunch I would use a Dillion but for small batches I can see the value in this.
Wayne
 
I created my own case kicker on my Redding Big Boss II. It consists of a paper clip (wire) and a rubber band. Anyone can do the same. I use it when I am sizing and depriming brass. Saves a bunch of time.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,828
Messages
2,204,056
Members
79,148
Latest member
tsteinmetz
Back
Top