• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

I'm About to Chamber My First Barrel; Any Advice?

Did you use an adl trigger guard or one of the 40x ones? Just wondering how you filled that front guard screw hole with the elongated hole in the stock?
Someone cut this stock for BDL. I used stock 700 bottom metal.
 
Congratulations On Your First Chamber . It should shoot just fine. I remember a customer of mine a few years ago shot a rifle at my backyard range, I had just chambered for him the first two shots went thru the same hole. He looked up at me and said "and to think it was made by a nobody" I was like thanks a lot.
All that to say it's not rocket science just good set up and preparation. And a good barrel
 
"Thank you to all from this board that helped with encouragement and discouragement... it all pushed me to do the best I could on this project. I learned a ton."

The target says it all.
You done good!
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,346
Messages
2,216,900
Members
79,554
Latest member
GerSteve
Back
Top