How much should your die be sizing

[L.Sherm]

I'll take .003 sizing all day long at the. 200 with Lapua brass

 

[Mike TackleBerry]

On my 300 PRC i like to bump the shoulders .0015

 

[Webster]

I have 3 pieces of brass at Whidden now, waiting for reply. Asked the builder and he said use RCBS, claimed that much resize ain’t bad. (I feel like it’s?)
So when you say I’m over pressuring the .200 line.. If the chamber isn’t supporting that area, are you saying the brass won’t grow as long as I’m not over pressure? So my chamber is 7thou bigger then new brass, won’t new brass blow out that 7 thou on first fire? Or will that brass hold strong unless over pressure? No other pressure signs.. Didn’t have any issues till 3rd firing of this brass. And not sure it really an issue, just a lil heavy bolt, which is what made me dig into all this and figure it all out. Thanks

Are your loads a little on the hot side. Back of 1-2 gr. and see if the problem goes away. Don't want to strain my brain but 1 of your three dies should work???

 

[RyeGuy]

Not being a wise guy, if you don't trust the builder of the gun why would you let him build it? RCBS will not size it too much. You're good with that, you do not want bolt click or hard bolt lift. I can promise you sizing correctly will not affect accuracy!

True.. Just looking for more opinions. Thanks

 

[Steve Donlon]

If you are worried about over sizing your brass use a Redding Body Die after that use a neck sizing die. I have used RCBS FL sizing dies for all my different cartridges, but have decided to try the body die on all the brass I am neck sizing to see the difference. The body die, then neck sizing is supposed to be easier on the brass. It's all Starline brass that I'm using for this. So far i have had very good results with accuracy. But I have not reloaded any, more than a few times to see how long the brass holds up.