jxb
Gold $$ Contributor
Offering HNT26 LOP spacers with hardware for sale. These are printed using PLA CF to order by my 3D guy. I currently have a couple on-hand in 1" and 1.5" lengths. They insert between the stock and the action and include a round coupling nut plus a set screw matching the length of the spacer. These allow you to insert/remove as needed and have been tested with the folder but should work with the non-folder as well. The idea is to increase LOP without changing the shoulder to cheek rest distance and much lighter than the factory spacers. Please note that on the folder, the overall length folded does increase by the length of the spacer installed.
Parts included in a set:
3D printed spacer, XTN male/female ends same as the stock and action.
18-8 Stainless Steel 3/8"-24 Cup-Point Set Screw (3/16 hex) (length matching printed spacer)
Round Coupling Nut: 18-8 Stainless Steel, 3/8"-24 Thread Size 1" length
Pricing shipped, per order: (USPS small flat rate box)
$55 for one kit
$44 each addition kit
$31 each additional spacer (for use with existing kit).
PM me for my contact info, address, and availability. Let me know which length(s) you want.
If parts are on-hand gold/silver members order will ship when the check arrives. All others will ship when the check fully clears (5-7days).
Below pics show a 1" spacer installed with a 1.5" and hardware next to it. The other shows the fit.
For reference a 1" kit weighs 1.4oz (~40 grams)
A big thank you to MDT for helping make this project a success. They provided the XTN interface data necessary.
My original thread:
'https://forum.accurateshooter.com/t...at-includes-some-design.4132487/post-39023567'
-- Jeff
Parts included in a set:
3D printed spacer, XTN male/female ends same as the stock and action.
18-8 Stainless Steel 3/8"-24 Cup-Point Set Screw (3/16 hex) (length matching printed spacer)
Round Coupling Nut: 18-8 Stainless Steel, 3/8"-24 Thread Size 1" length
Pricing shipped, per order: (USPS small flat rate box)
$55 for one kit
$44 each addition kit
$31 each additional spacer (for use with existing kit).
PM me for my contact info, address, and availability. Let me know which length(s) you want.
If parts are on-hand gold/silver members order will ship when the check arrives. All others will ship when the check fully clears (5-7days).
Below pics show a 1" spacer installed with a 1.5" and hardware next to it. The other shows the fit.
For reference a 1" kit weighs 1.4oz (~40 grams)
A big thank you to MDT for helping make this project a success. They provided the XTN interface data necessary.
My original thread:
'https://forum.accurateshooter.com/t...at-includes-some-design.4132487/post-39023567'
-- Jeff
Last edited:
