Seekins Havak PH2 recoil pad spacer

[tac284]

Have a friend who is needing to increase length of pull by at least 1/2” on his new Seekins Havak PH2. Apparently they made these rifles with 13” LOP.

I read a comment on RokSlide from 2022 that Seekins was going to make spacers but it appears they haven’t gotten around to it yet.

Has anyone on here 3D printed any yet that would be willing to make me one?

 

[280ai]

Try a Bergara HMR they look similar and they are about 1/2 inch thick. If you can't get one PM me I have an extra.

 

[tac284]

Try a Bergara HMR they look similar and they are about 1/2 inch thick. If you can't get one PM me I have an extra.

Could be a potential candidate, they seem a little hard to find though…

 

[Adam in WI]

Any luck with this?

 

[tac284]

He ended up having a guy 3b print one.