Front rest forend stop

[grovey]

I have an older Bald eagle front rest and it's missing the forearm stop. Where can I buy one of these? The only one I saw for sale was made by Sinclair, and that one won't work. My stud is 5/16.

 

[TheOtherZilla]

Just make one..

 

[Big Mc]

I have an older Bald eagle front rest and it's missing the forearm stop. Where can I buy one of these? The only one I saw for sale was made by Sinclair, and that one won't work. My stud is 5/16.

HomeDepot has everything. Like the last post just make one. allthred and wing nuts and you are good to go.. Tommy Mc

 

[grovey]

I don't need the stud, just the upright part the stock butts too. Making one would be a last resort .Here's a pic.

 

[Richard Coody]

http://www.sinclairintl.com/shootin...uxe-forend-stop-sku749101026-55230-75051.aspx

 

[Big Mc]

http://www.sinclairintl.com/shootin...uxe-forend-stop-sku749101026-55230-75051.aspx

3/16 x3/4 flat iron drill 5/16 hole mount with nut to your shaft. good to go..cut to length..

 

[riverwolf1]

Better yet get a piece of delrin round 3/4" X1" drill a hole the size of the stud sticking out, then drill a hole in the end and thread 1/4'X20 thread, pick up a 1/4X20 thumb screw at Home Depot and screw it in.

 

[Richard Coody]

I have an older Bald eagle front rest and it's missing the forearm stop. Where can I buy one of these? The only one I saw for sale was made by Sinclair, and that one won't work. My stud is 5/16.

FITS BALD EAGLE STOP RODS;
I bought this stop to replace the OEM part that was included with my Bald Eagle rest. Fits perfect since rod diameter is also 3/8", regardless of flat-sided Bald Eagle rod. This stop is fully adjustable for cant and height, great replacement!!!

 

[grovey]

Thanks for the replies and PM's . Richard I think that one is going to work out after all. I misread the description the first time around, so thanks to all for straightening me out.

 

[c.j.rhodes]

I have an older Bald eagle front rest and it's missing the forearm stop. Where can I buy one of these? The only one I saw for sale was made by Sinclair, and that one won't work. My stud is 5/16.

BUILD YOU ONE!

 

[timeout]

All the recent chatter about emojis and I can't find the zombie emoji. Darn the bad luck!

 

[Joe Maisto]

Just make one..

I had one on my rest , along with a speed screw at the rear of the rest . It served me well . But then... sitting next to “ Jack” on the firing line , couldn’t help but notice him shooting . A Sinclair inexpensive rest , no front stop , and squeezing the bag . HOFer long ago , and we began shooting about the same time some 24 years ago . He just did a whole lot more of it than I . Go figure ...