Flavio Fare Whisper BR 2.1 Trigger Help

[JohnW...ski]

Maybe someone here has run into the same situation.

A friend asked me to try his FF BR 2.1 trigger yesterday after a match. Not sure what the trigger pull was, after about 1/4 inch of take up it stopped and then easily and cleanly fired, but it was not nearly as light as factory and more like a two stage trigger.
My friend said he adjusted it by the instructions.

I cannot for the life of me figure out where the take up issue came from and am reluctant to try adjusting it for him.

Just for the record I have four of these triggers and couldn't be happier with mine. The first two came out of the box at .7 oz. pull, and the next two came closer to .9 oz. All I did to mine was increase the trigger pull to just under 1-1/4 oz.

So, has anyone run into this? Is it a real problem? Or, just readjust it?

Thanks,

John

 

[Sandbagger1]

I’ve got five of them and never a problem one. Like yours mine were all between.7-1.0 oz

 

[furrybean]

Contact them. They are very helpful but remember the time difference

 

[bichettereds]

I would adjust the sear engagement and trigger pull per the instructions. If that doesn’t work contact Fabio.

 

[Boilermaker]

When I adjusted my flavio per the instructions it caused the same issue you described. I found there was too much sear engagement. I decreased the sear engagement and everything works great now. I think the instructions call to tighten the sear engagement screw until the firing pin drops then back off 1/2 turn. I backed off 1/4 turn to get the mushy feel out.

 

[JohnW...ski]

Thanks guys, I feel better now that I have seen some of your replies. I will take a shot at readjusting it.

Thanks again.

 

[bichettereds]

When I adjusted my flavio per the instructions it caused the same issue you described. I found there was too much sear engagement. I decreased the sear engagement and everything works great now. I think the instructions call to tighten the sear engagement screw until the firing pin drops then back off 1/2 turn. I backed off 1/4 turn to get the mushy feel out.

Same here!

 

[JohnW...ski]

Got it adjusted, no creep before letoff and just under 1.0 oz. pull.
Thanks all.