• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Edit 1::::::Installing Front Sight base on Marlin 336-1895 ect

Going to #8 screw will cause you all kind'a problems, as bad a problem as you have now. Front sight ramps come with the needed screws, use them. It'll look Bubba other wise.
if i get a new ramp, i will definately use the screws that come with it. if i use the old ramp i need to get a new screw. i really dont know what size the old screw was but ill figure something out.
 
If the screw is broken and in the hole, plunge right down the middle of it with a 7/64 4 flute center cutting endmill. when you reach bottom, the remainder screw will most likely jump out and up the cutter. If not, its fairly easy to pick it out or unscrew it with a small torx bit.
Re tap the hole with the right tap (6-48??) and use the black max. Its the same stuff used to hold on glue on ribs. If you apply it right (clean, no oil! ) it wont come off
i was thinking of using an endmill and i do think the screw was 6-48. thanks for that info
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,582
Messages
2,198,740
Members
78,989
Latest member
Yellowhammer
Back
Top