• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

digital scales help!!!

AC power noise. Is it your problem? Highly unlikely. 50 years ago (us old farts might remember this) power line noise (voltage variations and frequency variations) had a significant effect on electronic equipment performance. This was the age of analog electronics and "noise" was observable. Often if the kitchen was in use or the dryer was running and the A/C kicked on you would see the color TV screen shrink.Today's digital electronics are much less susceptible to input voltage variations This is partly due to the nature of digital versus analog signal processing and also the fact that the digital electronics are running at low voltages 3-5 volts so that power line voltage variations don't have as significant effect. Because of the sensitivity of these low voltage components the devices have additional voltage regulated internal power conditioning.

That being said it's important that you use a good surge protector. These devices do provide protection for your equipment. While much is made of protection from grid induced voltage spikes the more likely source is from lighting strikes in the vicinity of the device. Most will also provide some small degree of filtering.

Things to watch for around the house that are potential issues? Welding machines, high current draw inductive loads such as tables saws, planers, etc, especially on the same circuit. Ham radio transmitters (source of RF interference). While I haven't seen this in years older analog RF receivers such as analog TV and Radios which do emit some RF frequencies.

Often blamed but seldom an issue? Fluorescent lights (Excluding the desk light over the device), cell phones, LEDs, low power walkie talkies, side by side scales.
 
I use a small lithium ion battery on my Charhemaster Lite, and it weighs pretty darned consistent at the range.


However, in my shop, which has four big fluorescent lights, , it acts rather funny.
 
Does a surge protector like the Trip-Lite Isobar actually remove the “noise and transients” from grid power? I thought they just protected from large voltage spikes.


Thank you
The IsoBar provides noise filtering in addition to surge protection. The FX-120i uses an inexpensive wall wart for power, and it doesn't provide much protection against noise; it's one of the ways of keeping the price reasonable. It wouldn't be a concern with an expensive lab-grade scale, but that's one of the reasons why they cost thousands instead of hundreds. A battery pack is a good way to eliminate line noise, but then you have to keep it charged and remember to turn the scale on hours before you intend to use it; I prefer to filter the line power and leave the scale on 24/7/365.
 
I use a small lithium ion battery on my Charhemaster Lite, and it weighs pretty darned consistent at the range.


However, in my shop, which has four big fluorescent lights, , it acts rather funny.
Does the cable that comes with it fit the Chargemaster?

Thanks
 
I have florescent lights in my garage. Would changing out the florescent tubes for Led tubes make a difference?
It can't hurt . I did it just for "grins" and noticed I didn't have to "Tare" my scale as often . Like now ; every twenty loads instead of every five or six .
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
169,789
Messages
2,281,727
Members
82,313
Latest member
40in
Back
Top